Removing Packaging; Packaging Bracket Removal-Left And Right Sides; Preparing Ovens; Installation - Bosch HSLP751UC Mode D'emploi

Removing Packaging

Cut straps on the outside of the boxes.
1.
Remove the upper boxed unit of the combination oven
2.
and place on floor so that both shipping cartons can
be opened.
Perform the following steps on both units of the
3.
combination oven.
Remove the cardboard box by lifting it up and off
▯
the unit
Remove all top and side cardboard and foam
▯
braces.
Place the unit (leaving it on the shipping base) in
▯
front of the cabinet where it is to be installed.
Remove all accessories, racks, packing materials
▯
and literature from the oven cavities.
Unscrew unit from packaging brackets as shown in
▯

"Packaging Bracket Removal-Left and Right Sides".

Notes
The screws near the base mounting bracket of each
▯
unit are all Star-head (T-20 size). Only the one screw
that goes through the slotted hole in the mounting
bracket on the left and right sides of the unit needs
to be removed in order to lift the unit from the
mounting base. The screw circled in the image
below and marked as (A) is the screw that needs to
be removed.
Remove one screw only from each bracket. This will
▯
release the oven from the shipping base. Do not
remove any additional screws from the oven.

Installation

Pre-Assembly of the Combination Oven

Combination ovens require the two components to be
assembled prior to installing the combination unit into the
wall cabinet.
Note: The installation procedures differ between the
microwave, speed oven and steam convection oven
combination units. The parts contained in the square
tube parts box are common to all three installations.
8
Packaging Bracket Removal-Left and
Right Sides
Note: Actual bracket varies in appearance. The bracket
remains in the packaging base. The unit should stay on
the packaging base until ready to be lifted into cabinet
cutout or onto the lower oven.

Preparing Ovens

Place ovens in front of the cabinet where it is to be
installed so that they are in line with the cabinet cutout.
Check to be sure all packing materials have been
removed from the unit. Also remove the accessories,
oven racks, literature pack and any shipping materials
from inside the oven cavity. Check both ovens for a
double oven or combination oven installation.

Parts Provided

Parts Provided
Universal connector
bracket (2)--in parts box
on top of oven
Screws (16)--in red bag
inside parts box on top of
oven.