Important Safety Instructions; Appliance Handling Safety; Safety Codes And Standards; Electric Safety - Bosch HSLP751UC Mode D'emploi

IMPORTANT SAFETY INSTRUCTIONS

9
READ AND SAVE THESE INSTRUCTIONS
IMPORTANT: SAVE THESE INSTRUCTIONS FOR THE
F E S A T A N R T A D P O R E I M
LOCAL ELECTRICAL INSPECTOR'S USE.
INSTALLER: LEAVE THESE INSTALLATION
INSTRUCTIONS WITH THE UNIT FOR THE OWNER.
OWNER: PLEASE RETAIN THESE INSTRUCTIONS FOR
FUTURE REFERENCE.
WARNING
When properly cared for, your new appliance has been
designed to be safe and reliable. Read all instructions
carefully before use. These precautions will reduce the
risk of burns, electric shock, fire and injury to persons.
When using kitchen appliances, basic safety precautions
must be followed including those in the following pages.
WARNING
Do not repair, replace or remove any part of the
appliance unless specifically recommended in the
manuals. Improper installation, service or maintenance
can cause injury or property damage. Refer to this
manual for guidance. All other servicing should be done
by an authorized servicer.

Appliance Handling Safety

CAUTION
Unit is heavy and requires at least two people
▯
or proper equipment to move.
Do not lift appliance by door handle.
▯
Hidden surfaces may have sharp edges. Use
▯
caution when reaching behind or under
appliance.

Safety Codes and Standards

This appliance complies with the latest version of one or
more of the following standards:
UL 858, Household Electric Ranges
▯
UL 923, Microwave Cooking Appliances
▯
UL 507, The Standard for the Safety of Electric Fans
▯
CAN/CSA-C22.2 No. 113-M1984 Fans and Ventilators
▯
It is the responsibility of the owner and the installer to
determine if additional requirements and/or standards
apply to specific installations.
D A N

Electric Safety

V E S A
WARNING
Before you plug in an electrical cord or turn on power
supply, make sure all controls are in the OFF position.
Do not let cord hang over edge of table or counter or
touch hot surfaces.
Always attach plug to appliance first, then plug cord into
wall outlet. To disconnect, turn any control to "off", then
remove plug from wall outlet.
Do not operate any appliance with a damaged cord or
plug or after the appliance malfunctions or has been
damaged in any manner. It is unsafe to operate any
appliance with a damaged power cord or plug. If the
appliance has been damaged or malfunctions, safely
disconnect the appliance from the power supply, then
immediately contact an authorized servicer to inspect the
product.
To protect against electrical shock, do not immerse cord,
plugs or other electrical parts in water or other liquid.
For appliances equipped with a cord and plug, do not
cut or remove the ground prong. It must be plugged in to
a matching grounding type receptacle to avoid electrical
shock. If there is any doubt as to whether the wall
receptacle is properly grounded, the customer should
have it checked by a qualified electrician. DO NOT use
an adaptor or extension cord.
If required by the National Electrical Code (or Canadian
Electrical Code), this appliance must be installed on a
separate branch circuit.
Installer-show the owner the location of the circuit
breaker or fuse. Mark it for easy reference.
WARNING
Before installing, turn power OFF at the service panel.
Lock service panel to prevent power from being turned
ON accidentally.
Refer to Rating Label for more information. See Rating
Label section for rating label location.
Be sure your appliance is properly installed and
grounded by a authorized technician. Installation,
electrical connections and grounding must comply with
all applicable codes.
E E S T H N S I O C T R U S T I N
3