Installation With The Steam Convection Oven - Bosch HSLP751UC Mode D'emploi

Installation with the Steam Convection
Oven
Note: Do not place the oven into the wall cabinet until
after mounting the steam convection oven on it using the
universal connector brackets.
Remove the six (6) screws holding the combo service
1.
slide assemblies ((A) in illustration below) to the
support brackets. Use a magnetic screwdriver bit to
reach the screws through the large holes in the tops of
the slides.
The screw in position (A) in image below (nearest the
2.
inside edge, near control panel) must be moved to
allow the universal bracket to be positioned there.
Remove the inside screw (A) from the left support
bracket and reinsert it into the third hole (B) from the
outside edge of the support bracket.
Repeat for the right support bracket.
10
Reattach the slide assemblies using the holes near the
3.
inside edge of the support bracket. Align the slide
assembly parallel to the edge of the bracket and insert
the first screw in hole (C).
Insert all three screws for each slide assembly. Tighten
the screws but do not overtighten.
Note: When the correct holes are used, the front of
the slide assembly will extend just past the front edge
of the support bracket 3/16" (5mm). The slide
assembly will also be about 1/2" (12mm) from the
inside edge of the support bracket.
Install the two universal connector brackets to the slide
4.
assemblies using the screws provided. Tighten screws
securely, but do not overtighten.
Note: The universal connector brackets are
interchangeable for the left and right sides of the oven.
Be sure the taller vertical edge of the bracket is
positioned to the outside of the oven.