Connecting The Speed Oven Or Steam Convection Oven Electrical Conduit To The Lower Oven - Bosch HSLP751UC Mode D'emploi

Install the decorative trim.
5.
Position the decorative trim
piece so the flanges with
the holes in them face to
the rear of the oven.
Align the inner flanges with
the inside of the universal
brackets. Fasten with one
(1) screw each into the end
hole of the universal
bracket.
Tighten screws securely but
do not overtighten.
Place the steam convection oven unit on top of the
6.
universal connector brackets and fasten in place using
two (2) screws per side. Tighten the screws securely,
but do not overtighten.
Note: The existing screws in the steam convection
oven base help with alignment. When lowering the
steam convection oven into place on the universal
connector brackets, allow these screw heads to slide
into the slots as shown in the illustration below. The
screw nearest the front of the steam convection oven
should slide into the base of the slope at the front of
the bracket.
Continue to "Connecting the Speed Oven or Steam
7.
Convection Oven Electrical Conduit to the Lower
Oven".
Connecting the Speed Oven or Steam
Convection Oven Electrical Conduit to the
Lower Oven
Note: When installing the combination unit, the speed
oven or steam convection oven, the power cable must be
properly attached to the oven-mounted junction box. This
must be done prior to supplying electrical power to the
oven unit.
WARNING
9
Check to be sure that no electrical power has yet
been supplied to the oven.
Remove the oven-mounted junction box cover located
1.
on the top rear of the oven. (See image below).
Remove the cap from the conduit access hole in the
2.
side of the oven-mounted junction box.
11