Before Using The Oven For The First Time; Setting The Clock; Baking Out The Oven; Cleaning The Accessories - Bosch HCB738356M Notice D'utilisation

Before using the oven for the first time

In this section, you can find out what you must do before using
your appliance to prepare food for the first time. Read the
Safety information section beforehand.
Remove the appliance packaging and dispose of it
appropriately.

Setting the clock

After the appliance has been connected, the
four zeros flash in the display. Set the clock.
Press the button.
0
1.
The clock in the display shows 12:00. The time symbols light
up and the brackets are around
Use the @ or A button to set the clock.
2.
After a few seconds, the time that has been set is adopted.

Setting the hob

In this section, you can find out how to set the hotplates.

Switching the hob on and off

You can switch the hotplate on and off with the control knobs.
Setting a hotplate
You can set the heat setting for the hotplates using the hotplate
control knobs. Press the control knob for the required hotplate
and turn it to the required heat setting.
Heat setting 1 = lowest setting
Heat setting 9 = highest setting
Note: Hotplate temperature is regulated by the heat switching
on and off. The heat may also switch on and off at the highest
setting.
10
0 symbol and
0 .

Baking out the oven

Precleaning the oven
Remove accessories and hook-in racks from the cooking
1.
compartment.
Fully remove any remaining packaging, such as small pieces
2.
of polystyrene, from the cooking compartment.
Some parts are covered with a protective film. Remove the
3.
protective film.
Clean the outside of the appliance with a soft, damp cloth.
4.
Clean the cooking compartment with hot soapy water.
5.
Heating up the oven
To remove the new cooker smell, heat up the oven when it is
empty and closed.
Turn the temperature selector to the maximum temperature.
1.
Switch off the oven after 45 minutes.
2.
Recleaning the oven
Clean the cooking compartment with hot soapy water.
1.
Fit the hook-in racks.
2.

Cleaning the accessories

Before using the accessories, clean them thoroughly using a
cloth and warm soapy water.
Large dual-circuit hotplate and extended
cooking zone
The size of these hotplates can be altered.
Switching on the large area
Turn the hotplate control to position 9 - where you will feel a
slight resistance - then continue turning to
dual-circuit hotplate or extended cooking zone
Then immediately turn it back to the desired heat setting.
Switching back to the small area
Turn the hotplate control to
The small dual-circuit hotplate is particularly good for heating
small amounts.
Caution!
Never turn the hotplate control beyond the
õ / ç symbol = large
and reset.
Û
/ symbol to
õ ç
.
Û