Safety Information - Lenze EPL-10200-EI Instructions De Montage

Show/Hide Bookmarks
N

Safety information

1. People responsible for safety
Operator
The operator is any natural or judicial person, who uses the Drive PLC or in whose name the Drive PLC is used.
The operator, or the person designated by the operator as responsible for safety, must ensure that
all relevant regulations, instructions and laws are observed,
only qualified personnel work with and on the control system,
the Operating Instructions are available to the personnel for all activities that require them,
unqualified personnel are forbidden to work with and on the drive system.
Qualified personnel
Qualified personnel are persons who, as a result of their education, training and experience, and knowledge of the
relevant standards and directives, accident prevention regulations and operating conditions, have been permitted
by the person responsible for system safety to carry out the required activities and who are able to recognise and
avoid dangers that may thereby arise. (For definition of skilled personnel see VDE 105 or IEC 364)
2. Application as directed
Drive PLCs are components which are designed for the installation in electrical systems or machinery. They are
not to be used as domestic appliances, but for industrial purposes only according to EN 61000-3-2. The
documentation contains information on the installation according to EMC requirements.
When installing in machines, commissioning of the drive controllers (i.e. the starting of operation as directed) is
prohibited until it is proven that the machine corresponds to the regulations of the EC Directive 89/392/EEC
(Machinery Directive), EN 60204 60204 must be observed.
Commissioning (i.e. starting of operation as directed) is only allowed when there is compliance with the EMC
Directive (89/336/EEC).
The technical data as well as the connection conditions can be obtained from the documentation. The instructions
given must be strictly observed. Ensure climatic conditions as specified in EN 50178.
Warning: Drive PLCs are products with restricted availability according to EN 61800-3. These products can cause
interferences in residential premises. If Drive PLCs are used in residential premises, corresponding measures are
required.
3. Installation
The units must be installed according to the regulations given in the corresponding documentation.
The Drive PLC must be protected from impermissible loads.
Avoid touching of electronic components and contacts.
The Drive PLC contains electrostatically sensitive components, which can easily be damaged by inappropriate
handling. Electrical components must not be damaged or destroyed mechanically (health risks are possible!).
PM
EDK10200EV3 DE/EN/FR 5.0
L