Lenze EPL-10200-EI Instructions De Montage page 28

Show/Hide Bookmarks
Function control Drive PLC
Make the connection between the PC and Drive PLC and the PC system bus module ONLY when the
equipment is switched off !
4
2
Step
Connect the PC system bus
module
Switch on the supply
voltage for the Drive PLC.
Switch on the PC
Set up the communication
parameters
Load the project example
Start program
Are there any faults during commissioning or regular operation ?
1
GND
Comment
Do not forget bus terminating resistor
Follow the instructions for the system bus module.
The permitted voltage is +18 ... 30 V DC
Start the Drive PLC Developer Studio (DDS) software.
 "Drive PLC Developer Studio - Getting started",
Chapter 4.4.2
 "Drive PLC Developer Studio - Getting started",
Chapter 4.4
 "Drive PLC Developer Studio - Getting started",
Chapter 4.4.4
+18 ... 30 VDC / 0 V
X5
HI
LOW
120W
0

(120 Ω).
3
?
82plc017
See
7
?
?