Lenze EPL-10200-EI Instructions De Montage page 50

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Show/Hide Bookmarks
?
Troubleshooting and fault elimination
Display
Error
1)
Keypad
PC
63
Communication error to
ce2
CAN-IN2
64
Communication error to
ce3
CAN-IN1 with event or time control
65
BUS-OFF
ce4
(many communication errors oc-
curred)
91
External fault (TRIP-Set)
EEr
105
Internal fault
H05
74
Fault in program execution
per
79
Initialisation error during transfer of
pi
parameter set
75
Internal fault
Pr0
72
Faulty transfer of PAR1 with key-
Pr1
pad/PC
79
Internal fault
Pr5
1)
LECOM fault number
qáé>
Detailed information concerning system fault signals of the Drive PLC can be found in the
PDF manual "Drive PLC" (chapter appendix: System fault signals)
RM
Cause
CAN-IN2-object receives faulty data
or communication is interrupted
CAN-IN1-object receives faulty data
or communication is interrupted
The Drive PLC has received too
many incorrect telegrams via the
system bus and has been discon-
nected
A digital signal assigned to TRIP set
has been activated
A fault was detected in the pro-
gram.
A fault was detected during the
transfer of the parameter set to
the Drive PLC.
Parameter set does not match
Drive PLC
PAR1 is defective.
EDK10200EV3 DE/EN/FR 5.0
Remedy
Plug-in connection - bus module
Check FIF
Check transmitter
Increase monitoring time under
C0357/2 if necessary
Plug-in connection - bus module
Check FIF
Check transmitter
Increase monitoring time under
C0357/3 if necessary
Check whether bus terminator
available
Shield control of the cables
Check PE connection
Check bus load, if necessary,
reduce the baud rate
Check external encoder
Contact Lenze
Send the Drive PLC with the data
set (on diskette) to Lenze.
Correct the parameter set.
Contact Lenze
Repeat data transfer or load Lenze
setting
Contact Lenze
L

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Epl-10201-eiEpl-10202-eiEpl-10203-ei

Table des Matières