Projecting - Sony VPL-CX85 Mode D'emploi

Projecting

2 4 5
TILT
INPUT
ON/STANDBY indicators
Rear remote
control
detector
COMMAND
OFF ON
PIC
PJ NETWORK
MUTING
AUDIO INPUT
TILT/KEYSTONE
LENS
VOLUME
APA
MENU/
TAB AIR SHOT
FREEZE
1
Plug the AC power cord into a wall
outlet, then connect all equipment.
The ON/STANDBY indicator lights in
red and the projector goes into standby
mode.
2
Press the I /
1 key.
The ON/STANDBY indicator lights in
green and the Intelligent Auto-setup
starts. The lens protector opens, and the
PUSH
MENU
ENTER
3
4
6
1
2
4
5
powered tilt adjuster rises and stops at
the previously adjusted position.
Note
When the projector is turned on, the
Startup screen is projected.
For details on the Startup screen, see the
attached "Operating Instructions for
Memory Stick" stored in the CD-ROM.
Turn on the equipment connected to
the projector.
Press the INPUT key to select the
input source.
Each time you press the key, the input
signal switches as follows:
INPUT-A t INPUT-B t INPUT-C t VIDEO t S-VIDEO
To input from
Computer connected to
the INPUT A connector
Computer connected to
the INPUT B connector
Air Shot/Memory Stick
(when you use the Air
Shot/Memory Stick)
Video equipment
connected to the VIDEO
input connector
Video equipment
connected to the S VIDEO
input connector
Smart APA (Auto Pixel Alignment)
adjusts the picture of the connected
equipment so that it is projected clearly.
Notes
• For INPUT C, input of the "Air Shot" or
"Memory Stick" can be switched by
selecting with the INPUT C selection
menu, or pressing the
AIR SHOT key on the Remote
Commander. The Air Shot Home or the
Memory Stick Home is displayed on the
screen.
Press INPUT to
display
INPUT-A
INPUT-B
INPUT-C
VIDEO
S-VIDEO
key or the
23
GB
Projecting