Sony VPL-CX85 Mode D'emploi page 24

• If "Auto Input Search" is set to "On," the
projector searches for the signals from
the connected equipment and displays
the input channel where the input signals
are found.
For details, see "Auto Input Search"
on page 37.
• The Smart APA is effective for the input
signal from a computer only.
5
Switch the equipment to be connected
to output to the projector.
Depending on the type of your
computer, for example a notebook, or an
all-in-one LCD type, you may have to
switch the computer to output to the
projector by pressing certain keys
(e.g.,
/
LCD ,
VGA
changing your computer's settings.
F7
or
and
Fn
6
Adjust the upper or lower position of
the picture.
To adjust using the Remote
Commander
Press the TILT/KEYSTONE key on the
Remote Commander to display the Tilt
menu and adjust the tilt using the M/m/
</, keys.
24
GB
Projecting
, etc.), or by
/
Fx
To adjust using the control panel
Press f or F of the TILT key to adjust
the tilt of the projector.
to lower the
projector
TILT adjustment key
Powered tilt
adjuster
Notes
• When you adjust the powered tilt
adjuster with the TILT key, the V
keystone adjustment is performed at the
same time. If you do not want to perform
the automatic keystone adjustment, set
the V Keystone menu to "Manual." (See
page 39.)
• If you set the "V Keystone" adjustment
to "Auto," the "V Keystone" correction
is automatically adjusted. However, it
may not be perfectly adjusted depending
on the room temperature or the screen
angle. In this case, adjust it manually.
• Press the TILT/KEYSTONE key on the
Remote Commander until "V Keystone"
appears on the screen, and adjust the
value with the M/m/</, key. The
corrected value is effective until the
power turn off.
• Be careful not to let the projector down
on your fingers.
• Do not push hard on the top of the
projector with the powered tilt adjuster
out.
It may be occurred malfunction.
7
Adjust the horizontal trapezoidal
distortion (
the "Side Shot."
to raise the
projector
TILT
)of the picture with