Bosch IXO Notice Originale page 42

OBJ_BUCH-826-002.book Page 42 Tuesday, October 14, 2008 4:54 PM
42 | English
Fully automatic spindle locking (Auto-lock)
The drill spindle is locked when the On/Off switch 8 is not
pressed.
This enables screws to be screwed in, even when the bat-
tery is empty and allows for the machine to be used as a
screwdriver.
When the drilling spindle is locked, do not press the
On/Off switch 8 for more than 15 seconds. Other-
wise the power tool can be damaged.
Working Advice
Apply the power tool to the screw only when it is
switched off. Rotating tool inserts can slip off.
Up to 13 screwdriver bits can be stored on the side of the
battery charger 11. The fixture that holds the screwdriver
bits can be removed.
Maintenance and Service
Maintenance and Cleaning
Before any work on the machine (e. g., maintenance,
tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the
centre position. Unintentional actuation of the On/Off
switch can lead to injuries.
For safe and proper working, always keep the ma-
chine and ventilation slots clean.
2 609 932 675 | (14.10.08) Bosch Power Tools