Bosch IXO Notice Originale page 40

OBJ_BUCH-826-002.book Page 40 Tuesday, October 14, 2008 4:54 PM
40 | English
Changing the Tool (see figure B)
Do not use double-sided screwdriver blades that are
longer than 25 mm.
Insert the screwdriver bit 1 directly into the tool holder 2.
Eccentric Driver Head/Angle Driver Head/
Torque Attachment (see figures C
The eccentric driver head 12 enables screwdriving close
to edges.
The angle driver head 13 enables screwdriving at hard to
reach locations.
With the torque presetting ring 15 on the torque attach-
ment 14, the requested torque can be preset in 10 steps.
With the correct setting, the tool bit is stopped as soon
as the screw is driven flush into the material or when the
set torque is reached.
Assembly (see figures C–D)
For assembly of the attachments, pull the rubber cap 3 off
toward the front. Afterwards the attachments can be
mounted. The attachments can be mounted offset by
45°.
Dismounting (see figures E–F)
To dismount the attachments, turn the release ring 17 in
rotation direction and pull the attachment off toward
the front. Afterwards, mount the rubber cap 3 again.
2 609 932 675 | (14.10.08)
F)
–
Bosch Power Tools