Publicité
Les langues disponibles
Les langues disponibles
BASIC PLUS RAILING RACK
CONTENTS
1.
SPECIFICATIONS ______________________________5
2.
ASSEMBLY INSTRUCTIONS ________________________5
3.
INSTRUCTIONS FOR USE AND IMPORTANT INFORMATION _____5
4.
CONTACT INFORMATIONS _________________________5
1. SPECIFICATIONS
Max. railing distance/thickness:
Min. railing height:
Ingot length:
Support pro le (LxW):
Own weight:
Max. load capacity:
2. ASSEMBLY INSTRUCTIONS
• Open the screw cap with a screwdriver or coin.
• Remove mounting clip screw (Fig 2).
• Remove the setscrew. Set the rack on the railing and equalize the rack
clearances (approx. 700mm) to each other.
• Pull the rack onto the railing with the setscrew.
• Tighten the mounting clip screw.
• Tighten the setscrew.
• Check for rm seating by pulling back and forth.
• If necessary, pull the setscrews more tightly.
• Put the end caps back on and close them.
3. INSTRUCTIONS FOR USE AND IMPORTANT INFORMATION
• This top carrier is only suitable for vehicle with roof railings.
• Follow the assembly instructions precisely to ensure your top carrier is
properly installed and functions awlessly!
• Please remember: you are responsible for the correct and careful
assembly and installation of your top carrier. During assembly, make
sure that the carrying straps do not project past the outer roof edges
and that in roof carriers in which the clearance from the front carrying
straps to the rear carrying straps is not xed due to its design, the
clearance should be at least 700 mm. Before every trip, even short
trips, and at least after every 300 km, check for the secure and rm
seating of your roof top carrier and the fastenings along with the load
xation (or securing). The luggage must not project much past
the load area.
• Notice that your vehicle's driving behaviour changes when the load
carrier is loaded (side- wind sensitivity, curves and braking).
• The carrying straps must not project past the roof edges or drip rail (if
necessary, shorten)
• For reasons of tra c safety and energy savings, the carriers should be
removed when not in use.
• Fasten the load with suitable means (e.g. reliably secure using belts,
lashes or similar).
• The clearance of both top carriers should be at least 700 mm unless
otherwise speci ed by the vehicle manufacturer.
• Make sure you load uniformly with the lowest possible centre of
gravity and do not exceed the roof load stated by the vehicle
manufacturer.
• The permissible load bearing capacity is composed of the deadweight
of the top carrier, 4.7 kg, plus the payload.
• The permissible load bearing capacity of the top carrier is 75 kg and
must be distributed uniformly across the top carrier.
up to 1.10 m center/approx. 30 mm
approx. 25 mm
approx. 1200 mm
approx. 35 x 20 mm
approx. 4.7 kg
75 kg
• When transporting long goods, additionally fasten the front end to the
bumper. Adjust your speed to the load.
• Stay within the prescribed recommended speed. To prevent damage to
the vehicle roof, always have two people assemble and disassemble the
top carrier!
4. CONTACT INFORMATIONS
EAL GmbH
Otto-Hausmann-Ring 107
42115 Wuppertal, Germany
+49 (0)202 42 92 83 0
+49 (0) 202 42 92 83 – 160
info@eal-vertrieb.com
www.eal-vertrieb.com
5
Publicité
