Ryobi LSDT1202 Manuel D'utilisation page 6

GB
FR DE ES
NOTE: To prevent further shutdown of the battery, avoid
forcing the tool.
If releasing the trigger does not reset the battery and tool,
the battery pack is depleted. If depleted, the battery pack
will begin charging when placed on the lithium-ion charger.
TO INSTALL BATTERY PACK
See Figure 2.
Place the rotation selector in the center position.
Insert the battery pack into the product as shown.
Make sure the latches on each side of the battery pack
snap in place and that battery pack is secured in the
product before beginning operation.
TO REMOVE BATTERY PACK
Always remove battery pack from your tool when you
are assembling parts, making adjustments, cleaning, or
when not in use. Removing battery pack will prevent
accidental starting that could cause serious personal
injury.
Lock the switch trigger by placing the direction of
rotation selector in the center position.
Depress the latches on each side of the battery pack.
Remove the battery pack from the tool.
Battery tools are always in operating condition.
Therefore, the switch should always be locked when
not in use or carrying at your side.
SWITCH TRIGGER
See Figure 3.
To turn the drill on, depress the switch trigger. To turn it off,
release the switch trigger.
NOTE: When selector is in center position, switch trigger
is locked.
VARIABLE SPEED
See Figure 3.
The switch trigger delivers higher speed with increased
trigger pressure and lower speed with decreased trigger
pressure.
NOTE: You might hear a whistling or ringing noise from
the switch during use. Do not be concerned; this is a
IT NL PT DK SE
WARNING
WARNING
FI NO RU PL CZ
English
normal part of the switch function.
ROTATION SELECTOR
See Figure 3.
The bit rotation is reversible and is controlled by a selector
located above the switch trigger. With the drill held in
normal operating position, the direction of rotation selector
should be positioned to the left of the switch trigger for
forward drilling. The drilling direction is reversed when the
selector is to the right of the switch trigger.
Setting the rotation selector in the off (center lock) position
helps reduce the possibility of accidental starting when not
in use.
To prevent gear damage, always allow the chuck to
come to a complete stop before changing the direction
of rotation.
To stop the drill, release the switch trigger and allow the
chuck to come to a complete stop.
NOTE: The drill will not run unless the rotation selector is
pushed fully to the left or right.
Avoid running the drill at low speeds for extended periods
of time. Running at low speeds under constant usage may
cause the drill to become overheated. If this occurs, cool
the drill by running it without a load and at full speed.
KEYLESS CHUCK
See Figure 4.
The drill has a keyless chuck to tighten or release drill bits
in the chuck jaws. The arrows on the chuck indicate which
direction to rotate the chuck body in order to lock (tighten)
or unlock (release) the drill bit.
Do not hold the chuck with one hand and use the power of
the drill to tighten the chuck jaws on the drill bit. The chuck
body could slip in your hand, or your hand could slip and
come in contact with the rotating drill bit. This could cause
an accident resulting in serious personal injury.
BIT STORAGE
See Figure 5.
When not in use, bits provided with the drill can be placed
in the storage area located on the base of the drill.
2
HU RO LV LT EE
CAUTION
WARNING
HR SI SK GR TR