Prior To Operation - Hitachi CJ 18DGL Instructions De Sécurité Et Mode D'emploi

English
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery. If
you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the
battery and recharge it after it has cooled for a while.

PRIOR TO OPERATION

CAUTION
To avoid serious accident, ensure the switch is
in the OFF position, and pull out the battery.
1. Check the work area environment
Check the work area to make sure that it is clear of
debris and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
2. Mounting the blade (Fig. 5)
(1) Turn the tool upside down and press the lever down
as far as it goes; the lever will not return to its original
position.
(2) Insert the blade into the slot until it automatically
locks in place.
Blade holder
Chip cover
NOTE
Confirm the blade located between the groove of
roller. (Fig. 6)
Blade
Roller
12
Blade
Lever
Fig. 5
Blade
Fig. 6
3. Dismounting the blade
CAUTION
Never touch the saw blade immediately after
use. The metal is hot and can easily burn your
skin.
(1) Open the chip cover and press down on the lever to
remove the blade.
(2) The lever will remain in the open position, allowing
blade replacement to be performed with a single
hand. Simply insert the replacement blade until it
locks into position.
Blade holder
4. Adjusting the orbital operation
(1) This Jig Saw employs orbital operation which moves
the blade back and forth, as well as up and down. Set
the change knob shown in Fig. 8 to "0" to eliminate
the orbital operation (the blade moves only up and
down). The orbital operation can be selected in 4
steps from "0" to "3".
(2) For the hard material, such as a steel plate, etc.,
decrease the orbital operation. For the soft material,
such as lumber, plastic, etc., increase the orbital
operation to increase work efficiency. To cut the
material accurately, decrease the orbital operation.
Change knob
Roller
Chip cover
Fig. 7
Fig. 8
Blade
Lever