Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DAILY USE

1. Open the water tap.
2. Press the on/off button to activate the
appliance. Make sure that the appliance
is in setting mode, refer to 'SETTING
AND STARTING A PROGRAMME'.
• If the salt indicator is on, fill the salt
container.
USING THE DETERGENT
A
SETTING AND STARTING A
PROGRAMME
Setting mode
The appliance must be in setting mode to
accept some operations.
The appliance is in setting mode when, af-
ter the activation:
• All the programme indicators come on
• The display shows 2 horizontal status
bars.
If the control panel shows other conditions,
press the cancel button until the appliance
is in setting mode.
Starting a programme without
delay start
1. Open the water tap.
2. To set a programme, keep the appli-
ance door ajar.
3. Press the on/off button to activate the
appliance.
4. Make sure that the appliance is in set-
ting mode.
5. Press one of the programme buttons
again and again until only the indicator
B
30
A
20
-
+
C
• If the rinse aid indicator is on, fill the
rinse aid dispenser.
3. Load the baskets.
4. Add the detergent.
5. Set and start the correct programme for
the type of load and the degree of soil.
1.
Press the release button (B) to open
the lid (C).
2.
Put the detergent in the compartment
(A) .
3.
If the programme has a prewash
phase, put a small quantity of deter-
gent on the inner part of the appliance
door.
4.
If you use detergent tablets, put the
tablet in the compartment (A).
5.
Close the lid. Make sure that the re-
lease button locks into position.
of the programme that you want to set
is on.
• The programme duration flashes in
the display.
6. If you want, you can set the options.
7. Close the appliance door. The pro-
gramme starts.
• The display shows the programme
duration that decreases with steps of
1 minute.
Starting a programme with
delay start
1. Set the programme and the options.
2. Press the delay button again and again
until the display shows the delay time
you want to set (from 1 to 24 hours).
• The delay time flashes in the display.
3. Close the appliance door. The count-
down starts.
• The display shows the countdown of
the delay start that decreases with
steps of 1 hour.
• When the countdown is completed, the
programme starts.
ENGLISH
65

Publicité

Table des Matières
loading

Table des Matières