Emc Compliance Declaration - Beurer BF 408 Mode D'emploi

14. EMC Compliance Declaration

ELECTROMAGNETIC COMPATIBILITY INFORMATION
Table 1
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacture's declaration – electromagnetic emissions
The BF 408 is intended for use in the electromagnetic environment specified below.
The customer or the user of the BF 408 should assure that it is used in such an environment.
Emissions test
RF emissions
CISPR 11
RF emissions
CISPR 11
Table 2
For all ME EQUIPMENT and ME SYSTEMS
Guidance and manufacturer's declaration – electromagnetic immunity
The BF 408 is intended for use in the electromagnetic environment specified below. The customer or the user
of the BF 408 should assure that it is used in such an environment.
IMMUNITY test IEC 60601 test level Compliance level Electromagnetic environment – guidance
Electrostatic
± 6 kV contact
discharge (ESD)
± 8 kV air
IEC 61000-4-2
Power frequency
(50/60 Hz)
3 A/m
magnetic field
IEC 61000-4-8
Compliance Electromagnetic environment – guidance
The BF 408 uses RF energy only for its internal function. Therefore,
Group 1 its RF emissions are very low and are not likely to cause any inter-
ference in nearby electronic equipment.
Class B
± 6 kV contact
± 8 kV air
3 A/m
Floors should be wood, concrete or ceramic tile.
If floors are covered with synthetic material, the
relative humidity should be at least 30 %.
Power frequency magnetic fields should be at
levels characteristic of a typical location in a typi-
cal commercial or hospital environment.
14