Fcc Compliance Information; Fcc Compliance Statement - Beurer BY90 Mode D'emploi

No Bluetooth
®
connection

12. FCC Compliance Information

Baby Scale BY90
Responsible Party – U.S. Contact Information:
Beurer North America LP
1 Oakwood Boulevard, Suite 255
Hollywood, FL 33020
United States
1-800-536-0366
info@beurer.com

FCC Compliance Statement

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired
operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interferencein a residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Device outside range.
Bluetooth is switched off on
®
the scale.
No connection to the app.
Batteries in the scale are
depleted.
Scale has not been paired with
the app. Any measurements
completed before pairing
cannot be transferred.
Bluetooth range is about 50 feet (~15m). Walls
®
and ceilings reduce this range significantly.
Radio waves may also cause interference, so
do not place the scale near devices such as
Wi-Fi routers and microwaves.
Press the Bluetooth
appears in the LCD Display.
Completely close the app (including in the
background). Switch Bluetooth
on again on the mobile device. Power your
mobile device off and back on again. Remove
the batteries from the scale for a short period
and reinsert them. See FAQs at www.beurer.
com.
Replace the batteries.
Pair the scale with the app.
9
Button until the icon
®
off and back
®