Blender - SilverCrest SKM 500 B1 Mode D'emploi

GB
IE

Blender

Fig. 3
10
6) Slide the pusher
7) Insert the plug into the mains power socket.
NOTE
► Use the diagrams on the fold-out page for assembly assistance!
1) Place the blender onto the motor block
arrow on the holder with mixing knife
2) Turn the blender until the arrow
3) Fit the lid to the blender
the handle of the blender
the side next to the handle towards which the guide at the handle opens.
Rotate the lid clockwise so that the locking mechanism on the lid
gages in the guide at the handle of the blender
a little way to ensure that the locking mechanism has engaged in the slot.
4) Fit the blender closure
slide into the guides in the lid
it is firmly attached.
5) Insert the plug into the mains power socket.
into the filling shaft .
in a central position so that the
is pointing at the symbol
so that the lip of the lid
(Fig. 3). Ensure that the lip is positioned exactly at
Fig. 4
to the lid of the blender so that the plastic tabs
. Then rotate the closure
is pointing at the symbol
.
is exactly in line with
(Fig. 4). Press the lip down
by 90°, so that
SKM 500 B1
.
en-