Arktic 2x12L Mode D'emploi page 6

Installation of the machine
• All of the operations & installations should be
carried out exclusively by specialized trained
personnel, who must organize all the operational
and installation sequences with the aid of suita-
ble tools, in strict compliance with the applicable
regulations.
• This machine should be installed indoors and in
a well-ventilated environment placing on a level,
horizontal, dry, firm and clean surface. Allow at
least 15 cm clearance to the rear and at least 25
cm to the left and right for adequate ventilation.
• This machine is of the attended use and must be
Assembly / Disassembly
Attention: Always make sure the machine is unplugged from the electrical supply outlet & cooled down com-
pletely before assembly/disassembly.
Assembly the machine as in the below procedure:
1). Insert the big rubber gasket (A) at the bottom of
the bowl (2). (See Fig.1).
This has been already installed in the delivery in
each bowl. Two spare gaskets (A) are included
and need replaced if worn.
EN
2). Lower the bowl (2) slowly and fitted on the top
of cooling part.
Note: Add small amount of water on the gasket
(A) for lubrication.
3). Roll the O-ring down the tap shaft. Then, invert
and insert into the hole in the bowl (2). (See Fig. 2).
6
installed in place where it can be monitored by
trained personnel during operation.
• After installation, allow machine keep in upright
position for at least 10 hours before connect to
the electrical supply to switch on. This is to al-
low the refrigeration unit to settle down and avoid
hazard.
• No other appliances should be plugged into the
same socket as with this appliance.
• Wait about 10 minutes before switch on the ma-
chine again after it has been switched off or un-
plugged from the electrical power supply.
4). Then, push tap lever into the slot in front of the
bowl (2) and drop into place. (See Fig. 3).
It may need to bend a little bit backwards for
easy fit in. (See Fig. 4).
5). Insert the mixing paddle rod into the mixing
paddle. (See Fig. 5).
6). Hang the drip tray with the slots at the front of
the dispenser. (See Fig. 6).
7). Securely fix the bowl lid (1) to the bowl (1).
Note: Disassembly the machine in the reverse or-
der.