Arktic 2x12L Mode D'emploi page 5

• Never cover the machine during use. This may cause a fire hazard.
• Do not make any additional openings on the machine. Do not install any gadgets in the
appliance.
• Do not attempt to climb up to the top of the machine.
• No any part is dishwasher safe.
Intended use
• This machine is intended for professional use and
can be operated only by qualified personnel.
• This machine is designed only for dispersing cold
beverage such as orange juice, cola, etc. Any oth-
er use may lead to damage of the appliance or
personal injury.
Grounding installation
This appliance is classified as protection class I
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
Main parts of the machine
The machine consists of below main parts:
1. Bowl lid
2. Bowl
3. Main switch box (on right side)
4. Temperature control box (on left side)
5. Air vents (on both sides)
6. Dispenser
7. Tap lever
8. Drip tray
Accessories
(A). Spare big rubber gasket x2
(B). Spare tap shaft O-ring x2
(C). Tape shaft x2
(D). Drip tray x2
(E). Tap lever x2
Preparation before using for the first time
• Remove all protective packaging and wrapping.
• Check for the completeness of the machine and
its accessories (See == > Accessories). In case of
incomplete delivery or damages. Please contact
supplier (See == > Warranty).
• Place the machine on a level, horizontal, dry, sta-
ble and clean surface.
• This machine should be checked for its function
properly by specialized trained personnel.
• Operating this machine for any other purpose
shall be deemed a misuse of the machine. The
user shall be solely liable for improper use of the
machine.
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
1
2
4
5
6
7
8
• Clean all components as described (See == >
Cleaning and Maintenance).
Note: Due to manufacturing residues, the machine
may emit a slight odor in the first few cycles. This is
normal and does not indicate any defect or hazard.
Make sure the machine is well ventilated.
EN
3
5