Arktic 2x12L Mode D'emploi page 10

g) Regular check and maintenance
This machine must be periodically checked (for at
least every 6 months) by a specialized authorized
technician. This periodic check serves to ensure
that all the components installed and the machine
itself are at a high level of safety.
Troubleshooting
If this machine does not function properly, please
check below table for the solution.
Problem
The machine has no op-
eration after plug into
the electrical socket.
Dispenser tap leakage.
Liquid leakage from the
bowl (2).
EN
Cooling operation is not
started.
The mixing paddles does
not rotate.
10
Possible cause
The power cord and plug do not con-
nect firmly and correctly.
The main switch (a) inside the main
switch (3) is not pressed.
The tap shaft is not fitted correctly
The tap shaft O-ring (B) is not placed
correctly.
The bowl (2) is not fitted and mounted
correctly.
The big rubber gasket (A) is not placed
correctly.
The big rubber gasket (A) is worn.
Coolant refrigerant leak out.
The fan inside has no operation.
Air flow obstruct the cooling operation. Increase the spacing around the ma-
Mixing motor defective.
Any worn or borken parts must be replaced by
an original spare part. It is forbidden to use this
machine when even only one of its part is faulty or
worn.
If you are still unable to solve the problem, contact
the supplier/service provider.
Possible solution
Check again the connection. And
make sure all the connections are
firmly connected.
Press down the main switch (a) to the
"I" position.
Disassembly and check again the
position.
Disassembly and check again the
position.
Check again the position and reas-
sembly the bowl (2).
Check again the position and reas-
sembly again.
Replace with a new rubber gasket.
Contact the supplier.
Contact the supplier.
chine to have good ventilation.
Contact the supplier.