Set Iron Temperature; Steam Jet Function - SilverCrest SDRB 1000 C1 Mode D'emploi

BB&3(B%ERRN 6HLWH  0RQWDJ  -XOL    
• If your tap water is of medium hardness
or higher, please mix in some distilled
water:
Hardness of the Distilled water :
tap water
very soft/soft
medium
hard
very hard
• Your local waterworks will inform you of
the hardness of your water.
1. Disconnect the mains plug|10 from the
wall socket.
2. Turn the temperature controller|4 to
MIN.
3. Figure A: push the unlocking mecha-
nism|6 of the water tank|1 towards the
rear.
4. Hold the water tank|1 by the side
lugs|13.
5. Figure A: lift the water tank|1 up ver-
tically. The temperature controller|4 re-
mains on the device.
6. Open the cover|2 over the filler open-
ing|3.
7. Fill in the water with the measuring
beaker|15 up to the MAX mark on the
water tank|1.
8. Close the cover|2 over the filler open-
ing|3.
9. Place the water tank|1 onto the device.
The water tank must be heard to en-
gage with the unlocking mechanism|6.
46 GB
6.3
Mainte-
nance
symbol
tap water
0
1 : 1
2 : 1
3 : 1
1. Set the desired temperature using the
2. The control lamp|7 is lit for as long as the
6.4
~ Warning: risk of burns from steam and
sprayed hot water when using the
steam jet button|11. When using the
steam jet, always point the sole
plate|14 towards the item of laundry or
ironing board.
NOTES:
• The steam jet function requires a high
temperature.
• The steam jet function can be used with
or without the brush attachment|17.
1. Select a setting for the temperature con-
2. Start ironing as soon as the tempera-

Set iron temperature

Type of
tissue
Man-made fi-
bre, e.g. vis-
cose,
polyester
Silk, wool
Cotton, linen
temperature controller|4.
device is heating. It goes out when the set
temperature has been reached. You can
then begin ironing.

Steam jet function

DANGER! Risk of injury
through burning!
troller|4 between and MAX.
The control lamp|7 goes on.
ture has been reached and the control
lamp|7 goes off.
Tempera-
ture
controller