Safety System; Special Features; Start-Up; Switching On / Off / Selecting The Temperature - SilverCrest SWKK 100 A1 Instructions D'utilisation Et Consignes De Sécurité

Important safety instructions / Safety system / Special features / Start-up
heating pad during operation.
This poses a risk of injuries and /
or damage to the heating pad.
Always observe the information
on start-up, cleaning and care,
and storage.
If you have additional questions
on using our products, please
contact our Customer Service
Department.

Safety system

Note: The heating pad is equipped with a safety
system. The electronic sensor technology prevents the
entire surface of the heating pad from overheating
by automatically switching off in the event of a fault.
If the safety system switches the heating pad off au-
tomatically due to a fault, then the function display
on the control unit is no longer illuminated, even
1
if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.
Under no circumstances should you connect the
defective heating pad to another switch of the
same type. This would also result in a perma-
nent shutdown by the safety system in the
switch.

Special features

This heating pad has been pro-
vided with an especially soft
and hygienic velour fabric. The
textiles used in this heating pad meet the strict
human ecological requirements of Oeko-Tex
Standard 100, as verified by the German
Hohenstein Research Institute.
20 GB/IE

Start-up

Note: The heating pad may smell of plastic the first
time you use it, but this will disappear after a short
period of time.
To begin, first connect the control unit
heating pad with the plug-in connector
(see fig. B).
Then insert the mains plug into the socket.
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit
switch on the heating pad.
Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first 10 mi-
nutes of operation.
2
Switching off:
Set the control unit
heating pad.
Note: The operating display
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
ting the heating pad for several hours,
we commend setting the control unit
to the lowest setting to prevent
1
overheating and potential burns to the
part of the body heat is applied to.
to the
1
6
to 1, 2, 3, 4, 5 or 6 to
1
illuminates after
2
to 0 to switch off the
1
will switch off.
2
When opera-