Safety System; Preparing The Product For Use; Switching On / Off / Selecting The Temperature - SilverCrest SRNH 100 B2 Instructions D'utilisation Et Indications De Sécurité

Important safety instructions / Safety system / Preparing the product for use
· only use the heating pad in conjunction with
the control unit
pad (label),
· do not operate the heating pad without su-
pervision,
· do not switch the heating pad on if
it is folded or bunched up,
· do not cause any sharp creases in the heating
pad,
· do not place any objects, e.g. suitcase or
washing basket, on the heating pad when it is
switched on,
· do not place any sources of heat, e.g. hot wa-
ter bottle or similar, on the heating pad when
it is switched on.
These may all damage the heating pad.
Do not cover the control
on the heating pad when the pad is in operation.
The electronic components in the control
the heating pad cause the control
up slightly during operation.
Do not pull, twist or crease the cables. The
heating pad may otherwise be damaged.

Safety system

Note: the heating pad is equipped with a safety
system. The electronic sensor technology prevents
the entire surface of the heating pad from overheat-
ing by automatically switching off in the event of a
fault. If the safety system switches the heating pad
off automatically due to a fault, then the function
display on the control unit
2
minated, even if the heating pad is switched on.
Please note that, for safety reasons, the heating
pad must not be used after a fault and must be
returned to the service address indicated.

Preparing the product for use

Note: the heating pad may smell of plastic the
first time you use it, but this will disappear after a
short period of time.
90989_silv_Ruecken_Nacken_Heizkissen_content_LB1.indd 41
indicated on the heating
1
and do not place it
1
1
to heat
1
is no longer illu-
1
To begin, first connect the control
heating pad with the plug-in connector
(see fig. B).
Position the heating pad on your back so that
the fastener for the neck section is in the throat
area.
Then close the fastener.
Then adjust the length of the belt around your
stomach and fit the two ends of the connector
together (see Fig. C) to fasten the belt.
To open the belt, press the two catches on the
connector at the same time (see Fig. C).
Switching on / off /
Selecting the temperature
Switching on:
Set Level 1, 2, 3, 4, 5 or 6 on the control
of switch the heating pad on.
Note: The function display
heating pad is switched on.
Note: this heating pad features rapid heating,
which allows it to heat up within the first 10 minutes
of operation.
Switching off:
Set Level 0 on the control
heating pad off.
Note: the function display
nate.
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (level 6). This will
cause the heating pad to warm up quickly.
If you wish to leave the heated pad on for sev-
eral hours, set the lowest temperature (level 1).
to the
1
3
to
1
illuminates after the
2
to switch the
1
ceases to illumi-
2
GB 41
22.04.13 07:55