Switching On / Off / Selecting The Temperature; Temperature Levels; Automatic Switch-Off; Cleaning And Care - SilverCrest SRNH 100 D3 Instructions D'utilisation

Start-up / Cleaning and Care
Switching on / off / Selecting
the temperature
Switching on:
Set the control unit
switch on the heating pad.
Note: The function display
the heating pad is switched on.
Note: This heating pad features rapid heating,
which allows it to heat up within the first
10 minutes of operation.
Switching off:
Set the control unit
heating pad.
Note: The operating display
Selecting the temperature:
Just before using the heating pad, set it to the
highest temperature setting (setting 6). This will
cause the heating pad to warm up quickly.
When using the heating pad for several hours, set
it to the lowest temperature setting (setting 1).
ing the heating pad for several hours,
we commend setting the control unit
to the lowest setting to prevent over-
heating and potential burns to the
part of the body heat is applied to.

Temperature levels

Set the required temperature level on the con-
trol (see fig. A).
1
Level 0: off
Level 1: minimum heat
Level 2–5: customised settings
Level 6: maximum heat
10 GB/IE
to 1, 2, 3, 4, 5 or 6, to
1
illuminates after
2
to 0 to switch off the
1
will switch off.
2
When operat-

Automatic switch-off

Note: The heating pad switches itself off automati-
cally after about 90 minutes. The function display
then starts to flash.
Then select the setting 0 and after about 5 sec-
onds, reset the heating pad to the desired tem-
perature setting to switch it on again.
If the heating pad is no longer used after
the timer expires:
– switch off the heating pad (Setting 0),
– unplug from the socket,
– disconnect the plug-in connection
control unit , from the heating pad.
1

Cleaning and Care

LIfe BY eLeCTRIC SHOCk! Always
remove the mains plug from the socket
and the plug-in connector
from the heating pad (see fig. B) before cleaning
the heating pad. Otherwise there is a risk of
electric shock.
Use a dry, lint-free cloth for control unit
cleaning and care.
RISk Of DAMAGe TO THe
PRODuCT OR PROPeRTY!
Never immerse the control
water or other liquids. It may otherwise be
damaged.
If the heating pad is slightly soiled, use a
dampened cloth and a little liquid mild deter-
gent, if necessary.
RISk Of DAMAGe TO THe
PRODuCT OR PROPeRTY! Do
not use chemical cleaning or scouring
agents to clean the heating pad and control
The heating pad and control unit
wise be damaged.
The heating pad is machine-washable.
Set the washing machine at an extra
washing cycle for delicate items at
30 °C.
2
, i.e. the
3
DANGeR TO
with the control
3 1
1
in
1
.
1
may other-
1