Ironing; Cleaning - SilverCrest SDRB 1000 C1 Mode D'emploi

BB&3(B%ERRN 6HLWH  0RQWDJ  -XOL    
6.6

Ironing

FIRE HAZARD!
~ Before turning the device on, place it on
a level, stable, dry, heat-resistant sur-
face.
DANGER! Risk of injury
through burning!
~ The sole plate|14 becomes very hot.
Only touch the handle|8 and control el-
ements of the device during operation.
NOTES:
• The sole plate|14 cools down slightly
while you are ironing and therefore has
to be repeatedly heated back up to the
set temperature. During the heating pro-
cess the control lamp|7 lights up. You
can continue ironing at the same time.
• Sensitive fabrics are ironed at lower
temperatures and without steam.
1. Set the temperature controller|4 to
MIN.
2. Connect the mains plug|10 with the
wall socket.
3. Set the desired temperature using the
temperature controller|4. The control
lamp|7 lights up.
4. Start ironing as soon as the ironing
temperature has been reached and the
control lamp|7 goes out.
5. Finish ironing, set the temperature con-
troller|4 to MIN and pull out the mains
plug|10.
6. Allow the device to cool down.
7. Open the cover|2 over the filler open-
ing|3.
8. Pour any remaining water out of the
water tank|1 through the filler open-
ing|3.
48 GB

7. Cleaning

DANGER! Risk of electric
shock!
~ Pull the mains plug|10 out of the wall
socket before you clean the device.
DANGER! Risk of injury
through burning!
~ Allow the device to cool down before
cleaning.
CAUTION:
~ Do not use any astringent or abrasive
cleaning agents.
Cleaning the device
• For cleaning the device, use a soft,
moistened cloth.
• Dirt can be removed from the sole
plate|14 using commercially available
cleaning agents for chrome, silver or
stainless steel.
• Residues that have melted on the sole
plate|14 can be removed by heating the
device up to the MAX setting and then
ironing on an old cotton cloth.
Descaling
If the steam power is reduced after a certain
time, please descale the device.
• You should use a commercially availa-
ble limescale remover that is based on
citric acid to descale the iron. Please fol-
low the instructions for the limescale re-
mover.