Storage; Troubleshooting; Disposal - SilverCrest SDRB 1000 C1 Mode D'emploi

BB&3(B%ERRN 6HLWH  0RQWDJ  -XOL    

8. Storage

1. Set the temperature controller|4 to
MIN.
2. Pull out the mains plug|10.
3. Allow the device to cool down.
4. Open the cover|2 over the filler open-
ing|3.
5. Pour any remaining water out of the
water tank|1 through the filler open-
ing|3.
6. Store the steam brush by hanging it up
on the eyelet|9.

9. Troubleshooting

If your device fails to function as required,
please try this checklist first. Perhaps there is
only a minor problem, and you can solve it
yourself.
DANGER! Risk of electric
shock!
~ Do not attempt to repair the device your-
self under any circumstances.
Possible causes /
Fault
• Connect the device to
the mains power supply.
No function • Use the temperature
controller|4 to turn up
the temperature.
• Fill the water tank|1.
• Select a setting for the
temperature control-
Little or no
ler|4 between
steam
and MAX. The control
lamp goes on.
• Descale the device.
Steam jet is
not working.

10. Disposal

The symbol showing a wheel-
ie bin crossed through indi-
cates that the product
requires separate refuse col-
lection in the European Un-
ion. This applies to the
product and all accessories marked with this
symbol. Products identified with this symbol
may not be discarded with normal house-
hold waste, but must be taken to a collection
Action
point for recycling electric and electronic ap-
pliances. Recycling helps to reduce the con-
sumption of raw materials and protect the
environment.
Packaging
When disposing of the packaging, make
sure you comply with the environmental reg-
ulations applicable in your country.
Possible causes /
Fault
Action
• Fill the water tank|1.
• Select a setting for the
temperature control-
ler|4 between
and MAX.
• It may be necessary to
press repeatedly to trig-
ger the first jet of
steam.
• Leave a pause of a few
seconds between steam
jets.
49
GB