Maintenance; Changing The Filter - Sony CPJ-A300E Mode D'emploi

Maintenance

Note
Make sure that you
turn off the power
before changing the
filter.
Tip
If the filter is damaged,
consult your nearest
Sony dealer.
20
-GB Maintenance

Changing the filter

If the projector heats up because of a very dusty
filter, the projector displays "TEMPERATURE" and
stops operating.
1
Turn off the power and disconnect the mains lead.
2
Remove the dusty filter sponge.
Insert your finger into the groove by the filter and
push out the filter from the projector. Remove the
filter sponge from the filter.
yyyy
3
Place the supplied filter sponge into the filter, and
yyyy
replace the filter in the projector.
yyyy
Cleaning the filter sponge
You can use the same filter sponge after washing it.
Wash the filter sponge with water or a mild
detergent solution, and then rinse it.
Make sure that the filter sponge is completely dry
before replacing it in the projector.