Operation - Ryobi WS722 Manuel D'utilisation

To remove tile cutting wheel:
 Remove bevel table.
 Slide the hex wrench over the wheel arbor nut. Using
other hand, slide arbor wrench onto wheel arbor.
 Hold arbor wrench firmly to prevent the wheel from
moving. Turn arbor nut counterclockwise to loosen.
 Remove arbor nut, outer wheel washer, and cutting wheel.
INSTALLING THE SPLASH HOOD
See Figures 8 - 9, pages 13 and 14.
 Install the L-shaped splash hood bracket into the lip
located under the table behind the wheel.
 Install the screws into table and through splash hood
bracket then tighten securely.
NOTE: Be sure that hood bracket is aligned with cutting
wheel so that it does not interfere with material being cut.
 Align splash hood with wheel and slide over bracket. Line
up through holes in splash hood with slot in splash hood
bracket.
NOTE: Always adjust splash hood horizontally to table
and slightly above tile thickness. Hood should not be
touching tile.
 Install hex bolt through hood and bracket. Thread splash
hood knob onto bolt and tighten at desired height.
INSTALLING THE OVERFLOW DRAIN
See Figure 10, page 14.
 Locate hole on bottom of water fill reservoir.
 Firmly push and twist overflow drain into hole.
WARNING:
Do not allow familiarity with tools to make you careless.
Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes, resulting in possible
serious injury.
ASSEMBLY
FILLING THE WATER RESERVOIR
See Figure 11, page 14.
 Fill water reservoir with clean tap water to fill line.
NOTE: Overflow drain prevents overfilling.
 Replace or close bevel table.
To change reservoir water:
 Unplug tile saw.
 Remove or open bevel table.
 Remove overflow drain and empty into a bucket, do not
allow water to splash onto ground or around machine.
 Discard waste water in accordance with local regulations.
 Refill with clean tap water.
 Replace bevel or close table.
INSTALLING THE RIP GUIDE
See Figures 12 - 13, page 14.
 Hook the back of the rip guide onto the back rim of the
saw table.
 Lift locking lever and lower front of the rip guide to the
front of the saw table.
 Adjust the rip guide to the desired position using the rip
guide scales, located on front and rear of table, to set rip
guide to desired width of cut.
 Push the locking lever down to secure to the saw table.
When securely locked, the locking lever should point
downward.
INSTALLING THE MITER GUIDE
See Figure 14, page 14.
 Slide miter guide onto rip guide.
 Adjust to desired angle using angle scale and tighten
securely with miter guide knob.
 With rip guide at desired width, secure in place.

OPERATION

WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this tool. The use
of attachments or accessories not recommended can
result in serious personal injury.
APPLICATIONS
You may use this tool for the purposes listed below:
 Straight line cutting operations such as cross cutting,
mitering, ripping, and beveling
NOTE: This saw is designed to cut man-made tile, pavers,
natural stone products, and stone tile products only.
8 — English