Assembly - Ryobi WS722 Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully lift the saw from the carton and place on a level
work surface.
WARNING:
Do not use this product if any parts on the Loose Parts List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
 Do not discard the packing material until you have carefully
inspected and satisfactorily operated the tool.
NOTE: Most of the Loose Parts are stored in the water
reservoir.
 The saw is factory set for accurate cutting. After
assembling it, check for accuracy. If shipping has
influenced the settings, refer to specific procedures
explained in this manual.
 If any parts are damaged or missing, please call
1-800-525-2579 for assistance.
TOOLS NEEDED
See Figure 5, page 12.
The following tools (not included or drawn to scale) are
needed for assembly and maintenance:
 3 mm hex key
 Phillips screwdriver
LOOSE PARTS LIST
See Figure 6, page 13.
Tile saw
7 in. cutting wheel
Inner wheel washer
Outer wheel washer
Arbor nut
Bevel table
Splash hood with knob and hex bolt
Splash hood bracket
Overflow drain
Rip guide
Miter guide
Hex Wrench
Arbor Wrench
Operator's Manual (not shown)

ASSEMBLY

WARNING:
If any parts are damaged or missing do not operate this
tool until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this tool or create accessories not
recommended for use with this tool. Any such alteration
or modification is misuse and could result in a hazardous
condition leading to possible serious personal injury.
WARNING:
Do not connect to power supply until assembly is
complete. Failure to comply could result in accidental
starting and possible serious personal injury.
INSTALLING THE TILE CUTTING WHEEL
See Figure 7, page 13.
WARNING:
A 7 in. tile cutting wheel is the maximum wheel capacity of
the saw. Never use a wheel that is too thick to allow wheel
washer to engage with the flats on the spindle. Larger
wheels will come in contact with the splash hood, while
thicker wheels will prevent the wheel bolt from securing
the wheel on the spindle. Either of these situations
could result in a serious accident and can cause serious
personal injury.
 Unplug the saw and remove the bevel table.
 Slide inner wheel washer onto arbor, with small diameter
side flush against the motor.
WARNING:
Always install the inner wheel washer before placing
wheel on arbor. Failure to do so could cause an accident
since the wheel will not tighten properly. Never use
wheels that have openings, grooves, or teeth on this tool.
 Place the cutting wheel onto arbor and over sleeve on
inner washer, slide flat against inner washer.
NOTE: Be sure the arrows on the cutting wheel are going
in the counterclockwise direction.
 Place outer wheel washer onto arbor and larger diameter
flush against the cutting wheel. The double "D" flats on
the wheel washers align with the flats on the arbor.
 Install arbor nut onto arbor. Using wheel wrench and arbor
wrench, tighten arbor nut securely.
7 — English