Description - Hilti PD 42 Mode D'emploi

Symbols
Read the Return waste
operating material for
instructions recycling.
en
before use.
Laser Class Do not look
2 in into the
accordance beam.
with IEC/EN
60825‑1:2007
Battery status Hardware
indicator
KCC‑REM-
HLT‑PD42
Location of identification data on the tool
The type designation and serial number can be found on
the type identification plate on the tool. Make a note of
this data in your operating instructions and always refer
to it when making an enquiry to your Hilti representative
or service department.
Type:
Serial no.:

2 Description

2.1 Use of the product as directed
The tool is designed for measuring distances, adding and subtracting distances and offers many practical functions
such as a timer, area and volume measurement, min/max calculation, setting out, painter's area measurement,
Pythagoras function and data memory.
Do not use the tool as a leveling tool.
Measurements taken from plastic foam materials such as polystyrene foam, from snow or from highly reflective
surfaces (mirrors, glass, etc.) may produce inaccurate results.
The tool and its ancillary equipment may present hazards when used incorrectly by untrained personnel or when used
not as directed.
Take the influences of the surrounding area into account. Do not use the appliance where there is a risk of fire or
explosion.
Observe the information printed in the operating instructions concerning operation, care and maintenance.
22
Laser class II
according to
CFR 21, § 1040
(FDA)
>1/4s
Temperature
indicator
Unfavorable
errors operating
conditions