EHEIM incpiria marine 230 Mode D'emploi page 19

English
Adjusting/removing the doors
‧ You can readjust the doors (⌦D).
‧ The doors can be quickly removed/attached via the quick-release function (⌦E).
6. Commissioning
DANGER!
▶ Heed the operating manual for the feed pump and the LED light (only incpiria marine), especially the
chapters on safety, commissioning and operation!
CAUTION! Material damage due to overtightening of the hose connections.
Overtightening the hose connections can result in damage to the flat seals.
▶ Only tighten the hose connection union nuts by hand.
Place the filter basin (⌦G - view from the rear)
1. Place the filter basin onto the foam mat in the left side of the cabinet. Ensure that there is a gap of
approx. 5 mm to the side and rear walls.
Installing the inflow (⌦F/G)
1. Install the inflow elbow c onto the pre-installed inflow stand pipe.
2. Install the inflow pipe d with silicone tube to the pre-installed connecting piece.
3. Install the feed pump f in the collection chamber e of the filter basin.
4. Connect the feed pump to the silicone tube.
Installing the drain (⌦G)
1. Install the drain g with ball valve to the pre-installed connecting piece.
2. Install the smaller elbow and place the drain in the infeed chamber h of the filter basin.
Installing the emergency overflow (⌦H)
1. Install the emergency overflow pipe i onto the pre-installed connecting piece.
2. Install the larger elbow and place the emergency overflow between the filter chamber j and the
osmosis chamber k of the filter basin.
Installing the aquarium lighting (only incpiria marine) (⌦I)
1. With the continuously adjustable pull-out brackets you can adjust the LED light m to the width of
your aquarium. To do this, pull the pull-out brackets out of the lamp housings in the desired length.
2. Place the LED light in the profile l on the front sides of the aquarium. Make sure that the LED light
is secure
3. Insert the LED light's power cable into the profile.
4. Feed the cable through the triangular supply shaft into the base cabinet.
5. Connect the plug of the LED lights to the socket of the EHEIM power supply unit.
For maintenance work, the LED light can be pushed into the profile.
19