Kongskilde KDC 4000 Instructions De Service page 3

Take care that the guard for the V-belt transmission
is in correct position and fixed during operation.
Never put the hand in the
outlet of the trough auger,
while the cleaner is in
operation.
Location of lifting points for forklift
Location of lifting points
Floor brackets:
If the cleaner is mounted on a platform or similar,
it is important that the cleaner is secured against
falling down. It is therefore advised to bolt it to the
floor, by means of the two supplied floor brackets.
The floor brackets are attached to the angled brace
at delivery of the cleaner. They can be removed for
attachment onto the transport wheels´ axle. Hereaf-
ter the floor bracket can be bolted onto the floor.
Brackets for fastening the KDC 4000 to the floor
The brackets are attached onto the wheels´ axles
Height adjustment:
The height of the cleaner can be adjusted in both
ends by means of the telescopic legs. Lift the clean-
er above desired height, move bolts to a suitable
hole location, and lower the cleaner. Make sure the
cleaner rests on all four legs.
3