Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To connect several modules in cascade - fig. 17
•
Connect the first module to the system and gas pipes, as described above, but without fitting the blind flanges on
the opposite side to that of the connection.
•
Place the second module on this side, making sure to align the connection flanges and the condensate drain pipe.
Insert the seals contained in the kit between the flanges of the two modules.
•
Fit the bolts contained in the kit on the flanges from inside the first module, making them come out of the flanges
inside the second module. Partially tighten the nuts on the bolts from inside the second module.
•
Before tightening the nuts, make sure all the seals are correctly positioned and join the condensate drain pipes of
the two modules (see fig. 38).
•
Tighten the nuts and repeat the connection operations for the following modules (max.5).
If using a water trap
•
At the end, fit the blind flanges on the last module, inserting the special seals (fig. 16 and fig. 17).
If using a direct pump
•
Connect the delivery to the return on the last module (see fig. 18).
Plumbing connection using one generator with water trap
1
Gas inlet
2
System delivery
3
System return
4
Condensate drain
Plumbing connection using two or more generators with water trap
5
1
Gas inlet
2
System delivery
3
System return
4
Condensate drain
5
Blind flanges
6
Connection side
60
5
6
fig. 16
7
fig. 17
cod. 3540H322 - 09/2008 (Rev. 01)
Reply 51 - 71 - 101
1
2
3
7
4
5
Blind flanges
6
Connection side
7
Flanges with joining section
7
6
7
Flanges with joining section
8
Seals
1
2
3
1
2
3
7
4
1
2
3
EN
Publicité
Chapitres
Table des Matières
Dépannage
