Mounting And Operation - Bosch ART 23 SL Notice Originale

OBJ_BUCH-2058-004.book Page 14 Tuesday, January 3, 2017 11:21 AM
14 | English

Mounting and Operation

 Do not disassemble guard and metal tube once con-
nected.
 Do not connect the machine to the mains socket before
it is completely assembled.
 The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cut-
ting line to stop rotating before switching "on" again.
 Do not rapidly switch off and on.
 Remove any grass from spool cover when changing line
or spool.
 Only use Bosch approved cutting elements. Cutting
performance will vary with different cutting elements.
Check the guard screw is fixed tightly before using.
Check the tube joint is on correct position before using.
The machine will automatically feed and cut the line when the
tool starts and stops.
Troubleshooting
Problem Possible Cause
Trimmer fails to operate Power turned off
Mains socket faulty
Extension cable damaged
Fuse faulty/blown
Trimmer runs intermittently Extension cable damaged
Internal wiring of machine
damaged
Trimmer motor is stalling Grass too high
Trimmer does not cut Cutting line too short/broken off
Spool empty
Line can not be fed Cutting line too short/broken off
Line inside the spool entangled
Spool empty
Line retracts into spool Cutting line too short/broken off
Line keeps breaking Line inside the spool entangled
Trimmer used incorrectly
F 016 L81 433 | (3.1.17)
Action
Delivery Scope
Removing the Rubber Stop
Connecting the Tube
Mounting the Cutting Guard
Connecting the Extension Lead
Switching On and Off
Semi-auto feeding of 8 mm cutting
line when starting the tool
Removing the line spool
Mounting the line spool
Feed cutting line using manual feed
button
Maintenance, Cleaning and Storage
Selecting Accessories
Corrective Action
Turn power on
Use another socket
Inspect cable, replace if damaged
Replace fuse
Inspect cable, replace if damaged
Contact Service Agent
Contact Service Agent
Cut in stages
Feed cutting line using manual feed button (see
figure 9)
Replace the spool
Feed cutting line using manual feed button (see
figure 9)
Inspect the spool, rewind if necessary
Replace the spool
Rewind spool
Inspect the spool, rewind if necessary
Only trim with the tip of the line, avoid stones, walls
and other hard objects. Feed the line regularly to main-
tain full cutting width.
Figure Page
1 189
2 189
3 190
4 190
5 191
6 191
7 192
8 192
9 193
10 193
11 194
Bosch Power Tools