Noise/Vibration Information; Declaration Of Conformity; Mounting And Operation - Bosch ART COMBITRIM 23 Notice Originale

OBJ_BUCH-2342-001.book Page 13 Wednesday, October 29, 2014 10:34 AM
Trimmer
Cutting diameter
Cutting spool capacity
Weight according to
EPTA-Procedure 01/2003
Protection class
Serial number
The values given are valid for a nominal voltage [U] of 230 V. For different voltages and models for specific countries, these values can vary.
Please observe the article number on the type plate of your garden product. The trade names of the individual garden products may vary.

Noise/Vibration Information

Sound emission values determined according to EN 50636-2-91.
Typically the A-weighted noise levels of the product are:
Sound pressure level
Sound power level
Uncertainty K
Wear hearing protection!
Vibration total values (triax vector sum) determined according to EN 60335:
Vibration emission value a
h
Uncertainty K

Declaration of Conformity

We declare under our sole responsibility that the product described under "Technical da-
ta" is in conformity with all relevant provisions of the directives 2011/65/EU,
2014/30/EU, 2006/42/EC, 2000/14/EC including their amendments and complies
with the following standards: EN 60335-1, EN 50636-2-91.
2000/14/EC: Guaranteed sound power level:
Conformity assessment procedure according to Annex VI.
Equipment category: 33
Notified body:
SRL, Sudbury England, Nr. 1088
Technical file (2006/42/EC, 2000/14/EC) at:
Bosch Lawn and Garden Ltd., PT-LG/ENS23,
Stowmarket, Suffolk IP14 1EY, England
Henk Becker Helmut Heinzelmann
Executive Vice President Head of Product Certification
Engineering PT/ETM9
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
29.10.2014
Bosch Power Tools
ART 23 COMBITRIM/ ART 26 COMBITRIM/
ART 2300 COMBITRIM ART 2600 COMBITRIM
cm 23
m 8
kg 2.7
/II

Mounting and Operation

Do not connect the machine to the mains socket before
it is completely assembled.
The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cut-
ting line to stop rotating before switching "on" again.
Do not rapidly switch off and on.
Do not hand bump the line feed as it could be hot.
Remove any grass from spool cover when changing line
or spool.
Only use Bosch approved cutting elements. Cutting
performance will vary with different cutting elements.
Use the original spring when replacing spool.
English | 13
ART 30 COMBITRIM/
ART 3000 COMBITRIM
26
8
3.0 3.4
/II
see type plate on the garden product
3 600 H78 B..
3 600 H78 C..
3 600 H78 D..
dB(A)
dB(A)
dB
2
m/s 3.5
2
m/s
3 600 H78 B..
3 600 H78 C..
3 600 H78 D..
dB(A)
F 016 L81 210 | (29.10.14)
30
8
/II
85
95
=1
=2
96