Installation - Dometic TEC Série Instructions De Montage

Installation

9 Installation
!
CAUTION! Beware of injury
The generator may only be installed by qualified personnel from a
specialist company. The following information is intended for
technicians who are familiar with the guidelines and safety precautions
to be applied.
9.1 Note on installation
Read the installation manual carefully before you install the generator.
When installing the generator, note the following:
D
DANGER! Danger of electrocution
Disconnect all power supplies when working on the generator.
!
CAUTION! Beware of injury
• Improper installation of the generator can result in irreparable
damage to the device and put the safety of the user at risk.
• Always wear the recommended protective clothing (e.g. protective
goggles, gloves).
9.2 Securing the generator
Note on installation location
• Make sure that no combustible objects are stored or installed near the air outlet
or the ventilation slots. A distance of at least 70 cm should be kept.
• For safety reasons, note the location of existing wiring harnesses, wires and other
components within the installation area, in particular those which are not visible,
when installing the generator (when drilling or screwing etc.).
• Leave a space of at least 70 mm between the generator hood and surrounding
parts so that sufficient space remains for cooling air to pass through.
• For internal installation, you need to prepare a sealed compartment against the
vehicle interior which can also be insulated against sound.
Attach exhaust openings to the floor.
➤ Mount the gaskets to the casing and affix them with the srews (fig. 3, page 4).
➤ Position the casing in the desired area and attach it with the appropriate screws.
(fig. 4, page 4).
20
TEC60, TEC60LPG
EN