Oregon CS1500-092 Manuel D'instructions Original page 33

SYMPTOM
Chainsaw does
not cut properly
Chain loosening
or coming off of
guide bar
Bar and chain
excessively hot
and/or smoking
Chainsaw Model CS1500-092
Troubleshooting
POSSIBLE CAUSE
Insufficient chain tension
Dull chain
Chain installed
backwards
Worn chain
Dry or excessively
stretched chain
Chain not in bar groove
Side cover not
installed correctly
Chain is under-lubricated
RECOMMENDED ACTIONS
Tension the chain. See "Tensioning the Saw Chain"
in the "Preparing for Use" section of the manual.
See "Sharpening with PowerSharp
Install the chain with the teeth facing the correct
direction. See "Replacing a Worn Saw Chain and
Sharpening Stone".
Replace the chain. See "Replacing a Worn Saw Chain
and Sharpening Stone".
Check the oil level. Refill oil reservoir if necessary.
See "Filling the Bar and Chain Oil Reservoir".
Reseat chain onto groove. See "Replacing a Worn
Saw Chain and Sharpening Stone".
Properly install side cover ensuring the tab at rear of
side cover is tucked into saw body.
Check the oil level. Refill oil reservoir if necessary.
See "Filling the Bar and Chain Oil Reservoir".
®
".
33