Troubleshooting Guide - Einhell Rg-Es 1639 Mode D'emploi D'origine

Anleitung_RG_ES_1639_SPK1__ 04.04.14 11:30 Seite 19

12. Troubleshooting guide

Fault
Motor does not start
Engine performance drops
Imprecise scarifying result
Motor is running, roller is not
rotating
Important notice! To protect the motor itis equipped with a thermal overload switch which cuts out
when overloaded and starts again automatically after a short cooling-down period.
Possible causes
a) No electricity in plug
b) Cable defective
c) Switch, switch/plug block
defective
d) Connections to motor or
capacitor disconnected
e) Housing clogged
a) Soil is too firm
b) Housing clogged
c) Roller badly worn
a) roller worn
b) Wrong working depth
a) Toothed belt is torn
Rectification
a) Check line and fuse
b) Check
c) Have machine checked by a
customer service center
d) Have machine checked by a
customer service center
e) If necessary adjust working depth.
Clean housing so that the roller can
run freely
a) Change working depth
b) Clean housing
c) Replace roller
a) Replace roller
b) Correct working depth
a) By customer service workshop
GB
19