Descaling - Caffitaly System S9001 Mode D'emploi

Descaling signal: when the message "Descaling" appears on the display, it is advisable to run the descaling cycle, as
illustrated below.
The machine features an advanced programme that monitors how much water is used to dispense products.
This measurement lets the user know when the machine needs to be descaled.
Make sure to use Caffi taly System descaler, which is designed to respect the machine's technical
characteristics, in full compliance with consumer safety. The descaling solution must be disposed of
according to the manufacturer's directions and/or the regulations in force in the country of use.
Read the precautions given on the descaler package CAREFULLY. Avoid contact with eyes, skin and the
surfaces of the machine. Do not turn the machine off or raise the lever during descaling. A person must be
present during the operation.
Do not use vinegar: it could damage your machine!
• Empty and rinse out the used capsule drawer and drip-tray then refi t them (Fig.19 - 20 - 21).
• Place a container (at least 500 ml) under the dispensers (Fig.12 and Fig.15).
• Keep the buttons O1 and O2 pressed at the same time for 5 seconds. The message "Descaling" appears on the
display. Press the button O3 "OK" to start the descaling cycle.
• The message "Fill tank" appears on the display.
• Remove and empty the water tank (Fig.2).
• Mix the contents of a bottle of Caffi taly System descaler with approximately 2 litres of water and pour into the tank.
• Press the button O3 "OK". The message "Close levers" appears on the display.
• Raise the levers (N) and (P) to open the capsule compartment (Fig.4 and Fig.7).
• Insert the "cleaning" capsule, pressing it gently inside (Fig.5 and Fig.8).
• Completely close the levers (N) and (P) (Fig.6 and Fig.9).
• Press the button O3 "OK". The message "Confi rm start procedure" appears on the display.
• Press the button O3 "OK" again to start the cycle. The message "Running" appears on the display.
• The machine dispenses approximately 75 cc of descaling solution fi rst from the left dispenser and then from the
right dispenser.
• If the containers fi ll up, empty them out.
• After a 1 minute pause the dispensing is repeated. This is repeated 6 times.
• At the end of the last repetition, the machine dispenses the remaining solution from both groups at the same time,
until the tank is empty. The message "Emptying system" appears on the display.
• When the fi rst phase has been completed, the message "Fill tank" appears on the display.
• Carefully rinse out the water tank and refi ll it with fresh water (Fig.3).
• Empty and rinse out the used capsule drawer and the containers used, and put them back in place.
• Press the button O3 "OK". The message "Rinsing systems" appears on the display.
• The machine dispenses the rinsing water (until the water tank is empty).
• When the rinsing cycle has been completed, the message "Fill tank" appears on the display.
• Carefully rinse out the water tank and refi ll it with fresh water (Fig.3).
• Press the button O3 "OK" to exit the cycle.
• The machine is in the heating phase
• Raise the levers (N) and (P) to eject the "cleaning" capsules into the special drawer.
• Completely close the levers (N) and (P) (Fig.6 and Fig.9)
• Empty and rinse out the used capsule drawer, recovering the "cleaning" capsules, and refi t it together with the
drip-tray (Fig.19 - 20 - 21).
36 36
English

Descaling