Installation Of Fitting For In-Wall Installation (2-Part Function Block) - Franke ZAQUA015 Notice De Montage Et De Mise En Service

7.

Installation of Fitting for In-wall Installation (2-part Function Block)

7.1 Remove the cover plate.
☞
For further details please consult the Installation and Operating Instructions for the
fitting.
7.2 Use a hollow hexagon wrench to close the water volume regulators.
a: closed
b: open
7.3 Trigger the valve.
Spare parts
7.4 Disconnect the line connection between the solenoid valve cartridge and the
electronic module.
7.5 Remove the screws (c).
7.6 Remove the solenoid-valve cartridge (d).
☞
Other design forms of the solenoid-valve cartridge (d) are possible.
7.7 Use a flat nose pliers to pull the existing filter (e) out.
7.8 Continue with
Retrofitting thermal disinfection
7.9 Remove the screws (f).
7.10 Unscrew the plug (g).
☞
Use an M8 screw to pull out the plug via the centre thread.
7.11 Insert the new filter.
☞
Important!
Ensure correct installation position. The rib of the filter must not lie on the flow-
through hole.
7.12 Insert the solenoid-valve cartridge.
7.13 Tighten the screws.
7.14 Connect the line connection between the solenoid-valve cartridge and the electronic
module (k).
l: Solenoid-valve cartridge mixed water
m: Solenoid-valve cartridge bypass, thermal disinfection
☞
Insert an adapter (n) if necessary.
7.15 Mount the cover plate.
stap 7.11.
5