Plumbing Connection; Installation Of Mounting Assembly - Franke CE-50 Manuel D'installation

PLUMBING CONNECTION

If dishwasher and/or overflow is not to be
connected go on to next section.
If you are utilizing a dishwasher, this should
preferably be connected directly to the relevant
connection in the siphon. If a dishwasher connection
is not available in the siphon, complete the following
procedure:
Using a blunt instrument (steel punch or wooden
X X
dowel), knock out entire plug (fig. 2A). Do not
use a screwdriver or sharp instrument. (When
knockout plug falls into disposer, you may remove
it or grind it up when the disposer is used. This
will not damage the disposer in any way, but may
take some time to grind).

INSTALLATION OF MOUNTING ASSEMBLY

3
Sink
Elbow Flange & Screw Set (2)
Reset
Button
CE-50 / CE-75 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF
Removable
Splash Guard
Sink Flange
Plumber's Putty
(not included)
Groove
Fiber Gasket
Support Flange
Upper Mounting Ring
Mounting Screw
Retainer Ring
Cushion Ring
Lower Mounting Ring
Elbow
CE-XX
OR
Spring Clamp Ring
Elbow
2A
Dishwasher
Connection
Connect overflow hose (fig. 2B) using hose clamp.
X X
If hose size is different, you need a stepped
rubber adaptor.
Connect dishwasher hose (fig. 2B) using hose
X X
clamp. Make sure all plumbing connections are
tight and in accordance with all plumbing codes
and ordinances. Run water and check for leaks.
NOTE: The mounting components are assembled out
of the box in the same order they will be assembled
on the sink, so please pay close attention to the
order of the mounting system components before
you disassemble them.
The cushion ring and the lower mounting ring
X X
will remain attached to the disposer during
installation. Disassemble the other components
of the mounting assembly by rotating lower
mounting ring clockwise until the lower mounting
ring tabs slide off from the upper mounting ring
ramp. This will allow you to separate the upper
assembly from the remaining lower mounting
assembly.
Unscrew the 3 mounting screws until the upper
X X
mounting ring can be moved to the top of the
support flange. Remove the retainer ring with a
screw driver.
Keep the remaining parts placed together in the
X X
order they were removed. Before you connect
TE-XX
the disposer to the mounting assembly under
the sink, make sure the lower mounting ring is in
place and the black cushion ring is still engaged
properly to the top of the disposer opening. (Do
not remove the cushion ring.)
– 7 –
2B
Dishwasher
Hose
Overflow
Connection
Siphon
Connection
EN
Overflow
Hose