Franke CE-50 Manuel D'installation page 8

EN
Be sure the sink is clean. Install a bead of
X X
plumbers putty to the sink flange (1). From top
of the sink, push the sink flange down against
the sink opening to make a good seal (2). Do not
move or rotate the sink flange once it has been
seated or the seal may be broken.
Place a heavy object, such as the disposer (use
X X
a towel to prevent sink scratching) on top of the
sink flange to hold it down.
Take the remaining portion of the mounting
X X
assembly, that was put aside. From under the sink
insert the fibre gasket (3), then the support
flange (4), and then the upper mounting ring (5).
Hold the three parts in place while attaching the
X X
retainer ring (6) by pulling it apart and sliding it
onto the sink flange (7) until it snaps into the
groove of the sink flange (7).
3
4
5
Tighten the three mounting screws evenly and
X X
firmly against the supporting flange (8). Do not
over tighten.
Trim off any excess plumber's putty.
X X
Attach disposer onto the upper mounting ring
X X
by aligning the three mounting tabs on the
lower mounting ring with the slide-up ramps on
the upper mounting ring and rotating counter
clockwise.
CE-50 / CE-75 / TE-50 / TE-75 / TE-75S / TE-125 / TE-125BF
1
6
7
B
The lower mounting ring (which is part of the
X X
disposer) has 3 tabs that grab the mounting ring
ramp.
2
(A) points to the upper mounting ring.
(B) is the tab that slides up onto the "Ramp".
(C) is the „Ear" that is used to help rotate the lower
mounting ring.
Use a screwdriver for leverage if needed.
X X
Lift and turn the lower mounting ring counter
X X
clockwise until all three mounting tabs lock over
the ridges (F) on the slide-up ramps (D) of the
upper mounting ring.
E
8
As the lower mounting ring is turned counter
X X
clockwise each tab slides up onto the upper
mounting ring ramp (E) and locks in position over
the ridges (F).
Use a screwdriver or hammer for leverage if
X X
needed.
If a disposer needs to be removed, tapping on the
X X
Ear clockwise with a hammer will easily loosen
the lower mounting ring.
– 8 –
A
C
D
F