Connection Example; Assembly Instructions - Franke ZAQUA076 Notice De Montage Et De Mise En Service

8.

Connection Example

Example: Connection of 3-way valve
1 Electric T-junction
2 System line
3 Electronic module
4 Transformer 24 V AC
5 3-way valve
6 Power switch
7 Thermostat
8 Damp-room junction box with terminal block
Blind cap (not used)
Terminal of
junction box
1 ( )
2
3
9.

Assembly Instructions

9.1 Connect the power-switch plug to the correspondingly programmed actuator output
of the electronic module.
9.2 Connect the switching contact of the power switch according to its layout specifi-
cation shown on the label.
☞
When the switching contact is active, the corresponding LED on the power switch
lights up.
9.3 Connect the surface temperature sensor to the piping to be measured (see MBA 18-
05.646a).
9.4 Connect the system-line connector of the electronic module to the coupling of the
electronic T-junction.
Terminal in
3-way-valve

3 ( )

1
2
- 5 -
Core numbers at the
power switch
1
2