Wilo Stratos GIGA Série Notice De Montage Et De Mise En Service page 106

English
No. Designation
1.0.0.0 Setpoint
2.0.0.0 Control mode
2.3.2.0 p-v gradient
3.0.0.0 Pump on/off
4.0.0.0 Information
4.1.0.0 Actual values
4.1.1.0 Actual values sen-
sor (IN1)
4.1.3.0 Power
4.2.0.0 Operating data
4.2.1.0 Operating hours
4.2.2.0 Consumption
4.2.3.0 Countdown, pump
cycling
100
NOTE:
A few elements are hidden under certain conditions and are therefore
skipped in the menu navigation.
If, for example, the external setpoint adjustment under menu number
<5.4.1.0> is set to "OFF", the number <5.4.2.0> will be hidden. Menu
number <5.4.2.0> will only be visible if menu number <5.4.1.0> has
been set to "ON".
Type Symbol Values/explanations
Setting/display of the setpoint
±
(for further information, see
chapter 8.6.1 "Adjusting the
setpoint" on page 96)
Setting/display of the control
±
mode
(for further information, see
chapters 6.2 "Control modes" on
page 76 and 9.4 "Setting the
control mode" on page 108)
Constant speed control
Constant control p-c
Variable p-v control
PID control
Setting the gradient of p-v
(value in %)
ON
±
Pump switched on
OFF
Pump switched off
Information menus
Display of current actual values
Depending on current control
mode
p-c, p-v: Value H in m
PID control: Value in %
Current power input P
Display of operating data
The pump's total active operat-
ing hours (counter can be reset
via the infrared interface)
Energy consumption in
kWh/MWh
Time to pump cycling in h (at a
resolution of 0.1 h)
Display conditions
Not displayed for all pump
types.
Not displayed for manual
control mode
in W
1
The operating data refer to
the electronic module cur-
rently being operated
Shown only for double pump
master and internal pump
cycling Can be set in the
service menu <5.1.3.0>
WILO SE 10/2017