SDMO AT206 Manuel D'utilisation page 49

5.2 - DESCRIPTION OF THE CONTROL BUTTONS
Controls starting of the
generating set (active only
during operation in MANUAL
mode)
Controls closing of the
mains switch (active
only during operation in
MANUAL mode)
Controls closing of the
generating set switch
(active only during
operation in MANUAL
mode)
5.3 – OPERATIONS TO BE CARRIED OUT THE FIRST TIME CONTROL UNIT AT206 IS STARTED
When the control unit is switched on, the card automatically sets itself to RESET mode.
The equipment may be damaged if the guidelines for starting the control unit are not respected.
Before starting the equipment, check that the indications given on the identification plate are the same as the
specifications of the actual electrical system.
The correct time must be programmed into control unit AT206.
5.3.1 – Setting the time
To set the time, follow the procedure below:
- Press the RESET button.
- Press TEST for 5 seconds, until the word "Set" appears; then the screen will display the code for the first parameter. "U.01 - Weekly
test time interval".
- If the MEAS button is pressed several times, the card will display parameter "U.11". This parameter relates to the current time.
- Press the TEST button to set the time.
- Press the START button to increase the minutes or the STOP button to increase the hour.
- After having set the time, press RESET to save the value or press AUT to exit the parameter without saving it (the card displays
U.11).
- Press on AUT, then RESET to exit the menu and return to operation.
Changes the type of
measurement displayed
on the screen
Controls stopping of the generating set (active only
during operation in MANUAL mode)
15 / 32
Controls activation of
the weekly test
Controls operation in
MANUAL mode
Controls operation in
AUTOMATIC mode
Controls RESET
mode