SDMO AT206 Manuel D'utilisation page 35

CONTENTS
0.- PREFACE
1.- GENERAL INSTRUCTIONS
2.- PICTOGRAMS REPRESENTED IN THIS MANUAL
3.- SPECIFICATIONS
4.- DESCRIPTION OF CONTROL UNIT AT206
5 – DESCRIPTION, COMMISSIONING AND USE OF THE CONTROL UNIT
6 – PROGRAMMING CONTROL UNIT AT206
7.- TEMPORARY STORAGE
0.- PREFACE
This user manual forms an integral part of the automatic control unit and must stay with it throughout its life until it is no
longer serviceable.
For all operations, refer to the instructions contained in this user manual.
All of the instructions contained in this user manual must be strictly followed.
Use of the automatic control unit is prohibited to all personnel not having read and understood the contents of this user manual.
Take care of this user manual to ensure that its contents are always legible and store it in an accessible location where it can
easily be consulted.
This user manual must be passed on to any successive user or owner of the control unit.
1.- GENERAL INSTRUCTIONS
- This manual explains how to use the automatic control unit, describes the technical specifications, the instructions for installation and
fitting.
- Should you experience difficulties relating to its use or other problems, please contact our After-Sales department who will be on hand
to provide clarification or assistance.
- This manual must be stored in a safe and sheltered location, close to the automatic control unit and must always be readily available
for consultation.
- After having removed the packaging, check the integrity of the automatic control unit. If you have any doubts about its operation, do
not use the automatic control unit, but contact the selling agent to avoid invalidating the warranty.
- This automatic control unit must only be used for the purpose for which it has been designed. Any other use will be considered
improper and therefore dangerous.
- Our products are manufactured in compliance with current safety standards. As a result, it is recommended that all of the devices are
used and all instructions are observed such that the use of our product causes no personal injury or damage to property.
All operations relating to the installation of this control unit must only be carried out by qualified personnel and
in accordance with the current regulations in force.
- During use, it is recommended that the instructions relating to personal protection applicable in the country of use are strictly
observed, especially those relating to the wearing of work overalls, the wearing of protective goggles or gloves, etc.
- Never dismantle the automatic control unit if it is in operation.
- Do not modify the automatic control unit for any reason (the fixings, vents, electrical or mechanical components or others).
We refuse to accept any responsibility for injury to persons or damage to property caused by an unauthorised modification.
- Before carrying out any maintenance or cleaning operation, shut down the electrical control unit (switch it off).
- Do not expose the automatic control unit to direct sunlight or to any other source of heat. High temperatures can cause incorrect
operation of the electrical components.
- Ensure that the earth connection is correct.
USER MANUAL FOR AUTOMATIC CONTROL UNIT MODEL AT 206
1 / 32