Philips Azur GC4900 Série Mode D'emploi page 13

Problem
The iron does not
produce any steam.
The iron does not
produce a steam boost.
Water droplets drip
onto the fabric during
ironing.
The iron leaves a shine
or an imprint on the
garment.
4239_000_8855_1_Luxury Booklet A5_v4.indd 13
Possible cause
There is not enough water in
the water tank.
The steam slider is set to 'no
steam'.
The iron is not hot enough yet
to produce steam.
You have used the steam boost
function too often within a very
short period.
The iron is not hot enough yet
to produce a steam boost.
You have not closed the water
tank lid properly.
You are ironing while the
SmartLight is blinking.
You have put a chemical into the
water tank.
The surface to be ironed was
uneven, for instance because
you ironed over a seam or a
fold in the garment.
Solution
Fill the water tank (see chapter 'Preparing
for use', section 'Filling the water tank'.
Set the steam slider to MAX (see chapter
'Preparing for use', section 'Steam settings').
Wait until the SmartLight has stopped
flashing and lights up steadily.
Continue ironing in horizontal position
and wait a while before you use the steam
boost function again.
Wait until the SmartLight has stopped
flashing and lights up steadily.
Press the lid until you hear a click.
Wait until the SmartLight lights up steadily
before ironing.
Rinse the water tank and do not put any
perfume or chemical into the water tank.
The iron is safe to use on all ironable
garments. The shine or imprint is not
permanent and disappears when you wash
the garment. Avoid ironing over seams or
folds. You can also place a cotton cloth over
the area to be ironed to avoid imprints.
EnGlish
13
5/30/13 11:38 AM