Publicité
Les langues disponibles
Les langues disponibles
EN
7 MACHINE ATTENDANCE
MACHINE CLEANUP
CAUTION! Disconnect the Machine from the electric main and close water delivery cock before
cleanup.
Clean the machine regularly. Outer Machine's surfaces, parts of plastic and rubber materials should be
wiped with soft wet cloth only.
Wipe the gasket along its contour, in accordance with Fig. 1, by a soft dry cloth after every washing.
CAUTION! Take out the accumulations of foreign particles on the gasket of the door.
IT IS FORBIDDEN to use the chemical agents, abrasive compositions, alcohol, gasoline, and other
solvents to clean the Machine as they may damage it.
The detergents dispenser drawer needs periodic washing. For this purpose, pull the drawer out, and pr-
essing down a little to the snug of the lid, following the indicator, and take it out of the Machine (Fig. 17).
Take the shutter and caps out of the pan in accordance with Fig. 14 and flush carefully its outer and
inner surfaces under a jet of warm water. Flush the pan for detergents in accordance with Fig. 18. Insert the
detachable parts into the drawer's section and install the drawer into the Machine with no squeezing of
lateral surfaces of the section
If rusty objects have been trapped in the Machine together with laundry, stains of rust may appear that
needs to be taken out by the means of stainless steel objects' cleanup.
CLEANING THE WATER DELIVERY FILTERS
To clean the filters, proceed as follows:
– disconnect the filling hose out of the water delivery cock by turning the nut counterclockwise in
accordance with Figs 8;
– disconnect the filling hose from the solenoid-operated valve's threaded branch pipe in accordance
with Fig. 19;
– extract the filter out of solenoid-operated valve's branch pipe with flat pliers or a forceps in accord-
ance with Fig. 19;
– remove a trash from the filter, sweep by the brush and flush filters under the water jet.
Install in the filling hose and the solenoid-operated valve's threaded branch pipe in reverse sequence.
Connect the filling hose and check up the leakproofness of hose connections. Junctions should be dry during
Machine's running.
CLEANING THE PUMP FILTER
Check the drum for the presence of water prior to cleaning the pump filter. If the Machine does not
drain the water.
Clean the filter monthly and after the every washing of the goods with a long hair.
Drain the water remaining in the filter prior to cleaning. To do this, open the filter cover in accordance
with Fig. 20 with a screwdriver or some other tapering object. Draw the hose up to the stop out from the
Machine and place any container for collection of water in accordance with Fig. 21. Remove the plug from
the hose and drain the water in the container. Turn the filter knob counterclockwise in accordance with
Fig. 21 and remove the filter.
CAUTION! Water residues' bleeding is possible when turning the filter's knob.
Figure 17
46
, close the drawer gently.
Figure 18
solenoid-operated valve
�lter
Figure 19
Publicité
